02-20-2011, 02:47 PM
Hi,
In qm 2.1.6 one could list/{set the focus on} the macro that was most recently run by pressing F3 in the qm editor. In qm 2.3.2.8 this does not seem to work anymore.
Is there another way to do this or has this feature been left out? If so, will be it be re-enabled in future versions?
Bye, Arthur.
In qm 2.1.6 one could list/{set the focus on} the macro that was most recently run by pressing F3 in the qm editor. In qm 2.3.2.8 this does not seem to work anymore.
Is there another way to do this or has this feature been left out? If so, will be it be re-enabled in future versions?
Bye, Arthur.