When I press Ctrl + Shift + E, the following error message pops up. Is it possible to change this hotkey? I would like to customize it to Alt + F1.
https://i.ibb.co/k2NwVfCq/F4.png
Feature suggestion: Independently recognize controls that contain the “desc” field. In the demonstration below, I have to manually expand the nodes to locate the control. If the control could be recognized automatically, it would be much more convenient.
https://i.ibb.co/rKMzVR9W/demo.gif
PS: In almost all cases, the value of “desc” is unique, so if this field exists, it can be used as an important auxiliary property.
https://i.ibb.co/k2NwVfCq/F4.png
Feature suggestion: Independently recognize controls that contain the “desc” field. In the demonstration below, I have to manually expand the nodes to locate the control. If the control could be recognized automatically, it would be much more convenient.
https://i.ibb.co/rKMzVR9W/demo.gif
PS: In almost all cases, the value of “desc” is unique, so if this field exists, it can be used as an important auxiliary property.

about QM3 Some suggestions