02-06-2019, 02:47 PM
(This post was last modified: 02-06-2019, 02:52 PM by AggieBQ1972.)
WSJTX macro watches for the small box to popup that confirms a valid contact. macro clicks in the box to accept and then erase button (maybe backwards) and then the Enable TX button to start it all over again .
The WSJtart process all over.TX macro is set to run simultaneously. It waits until a contact is confirmed and a small box pops up. Macro then presses ERASE button one time, Clicks on I think a OK button in the box. This then logs the contact to a logging program and then it presses ENABLE to start the process all over.
The WSJtart process all over.TX macro is set to run simultaneously. It waits until a contact is confirmed and a small box pops up. Macro then presses ERASE button one time, Clicks on I think a OK button in the box. This then logs the contact to a logging program and then it presses ENABLE to start the process all over.