QM-2.09 still will not go past a request for password

[Alistair7]

I still have not found a solution to this problem.
When I try to access a password protected drive on another PC on the LAN,
the password window pops up, but the password is not typed in by the macro. It just freezes. QM2 remains red and active. I can type the password in by hand and press Enter. Then the macro continues.

But I want the password typed in by QM2.

spe 500
run "\\Natalia\c"
err
key "password"

What is the problem??

Alistair